Dry Filament Using an Active Drying System

To resolve moisture-induced print failure, perform the following steps:

1. Remove the filament spool from the AMS or printer holder.
2. Place the spool into an active filament dryer or the AMS 2 Pro.
3. Set the drying temperature according to the specific material type (e.g., 50-55°C for PLA, 65-70°C for PETG).
4. Run the drying cycle for at least 6 to 8 hours to ensure deep moisture removal.
5. Verify the fix by performing a test print; if the extrusion appears consistent and the model maintains structural integrity, the filament is sufficiently dry.

Sources