Repin the Laser Control Connector Cable

1. Identify the pinout labels on both the laser module and the new control board (e.g., PWM, GND, 12V).

2. Use a small flat-head screwdriver or pin extraction tool to carefully release the crimped pins from the plastic connector housing.

3. Reinsert the pins into the correct sequence to ensure the PWM, Ground, and Power pins from the controller match the corresponding inputs on the laser module.

4. Secure the connector back into the control board and verify all pins are firmly seated.

5. Test for functionality by sending an M3 S255 command to ensure the laser fires reliably.